Configuration summary

On this page you will find a summary of the configuration you have made, which will be sent to our sales department for further processing after your confirmation.

L1=50L3=10L2=2R=0.1D1=2D2=4D3=1.91α=16°2D1=2
Source Article EXN1-M16-0063-2X10
Corner chamfer angle 45 °
Corner radius (R) 0.1 mm
Corner type Corner radius
Cutting diameter (D1) 2 mm
Cutting direction Right
Cutting edge count (Z) z2 #
Cutting end diameter (D4) 2 mm
Cutting geometry Center cutting
Cutting length (L2) 2 mm
Cutting profile Default
Helical pitch 45 °
Polished flutes Application specific
Spiral direction Left
Tip angle 90 °
Total length (L1) 50 mm
Unequal tooth pitch Application specific
Coating Application specific
DIN material N
Material N1.1
Milling cutter type Formmaker
Milling operation Full slot milling
Cooling Dry
Cooling duct No
Chamfer length (shank) 0.4 mm
Shank diameter (D2) 4 mm
Weldon HA - without weldon
Angle alpha (α) 16 °
Angle beta (β) 0.0
Undercut diameter (D3) 1.91 mm
Undercut geometry Straight undercut
Undercut length (L3) 10 mm

Possible alternative products

Is a special milling cutter really necessary? Alternative products from our catalog:

Request a quote

0 / 2048
Back